Chapter 19 Control Panel Setup (Panel)
1162
Auxiliary Bus Control Block Settings (Aux Assign Menu)
Using the Auxiliary Bus Control Block for Router
Control
To make router control settings, display the Setup >Panel >Aux Assign >RTR
Mode Setting menu.
To display the RTR Mode Setting menu
1
In the Engineering Setup menu, select VF2 ‘Panel’ and HF3 ‘Aux Assign.’
The Aux Assign menu appears.
2
Press [RTR Mode Setting].
The RTR Mode Setting menu appears. The left of the status area shows the
destination number assignment status and source table, and the right side
lists the destinations that can be assigned.
Assigning a destination to a destination selection button
In the Panel >Aux Assign >RTR Mode Setting menu, use the following
procedure.
1
Using any of the following methods, select a destination selection button
and the destination to be assigned to the button.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
• For a button whose operation you want to disable, press [Inhibit].
Notes
When a destination selection button having a number in the range 65 to 128
is selected, source table selection automatically becomes invalid, and
therefore the Inhibit function also becomes invalid.
2
Press [Dest Set] to confirm the selection.
Knob Parameter Adjustment Setting values
1 Dest No Destination selection button
selection
1 to 128
2 No Destination selection in S-Bus
space
1 to 1024
To Next Page
Loading...
Need help?
General