Chapter 22 DCU Setup (DCU)
1278
Serial Port Settings (Serial Port Assign Menu)
3
Press [Clear].
Making Detailed Settings on the External Device
Connected to the Serial Port
After setting the external device for each serial port, it is necessary to make
further detailed settings for operation of the external device.
Making detailed settings for a P-Bus device
1
In the DCU >Serial Port Assign menu, select the setting target (DCU1 or
DCU2) from the <DCU Select> group.
2
Using any of the following methods, select the serial port connected to the
P-Bus device for which you want to make the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) The range of setting values depends on the DCU port setting. (When the MKS-2700 is
connected, select 2 for the slot and a value in the range 1 to 6 for the port.)
3
Press [Port Setting].
The DCU >Serial Port Assign >P-Bus Setting menu appears.
At the top of the status area, the relevant serial port, slot number, protocol,
serial port name, and SCU number appear. In the lower part of the status
area, the device name and response speed settings appear.
4
Using any of the following methods, select the ID for which you want to
make a device name setting.
• Press directly on the device name list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
5
In the <Name> group, press [Set] to display a numeric keypad window.
Knob Parameter Adjustment Setting values
1 Port No Serial port number
1 and upwards
a)
Knob Parameter Adjustment Setting values
1 ID ID selection 0 to 23
To Next Page
Loading...
Need help?
General