Chapter 23 Setup Relating to Router Interface and Tally (Router/Tally)
1302
Parallel Tally Settings (Parallel Tally Menu)
Dest: Return a tally to the destination outputting the source to which a
source tally is returned.
5
Set the destination address and level.
The level setting is only required when in step 4 you selected Destination.
6
When setting the tally type, set the following parameter.
a) 1:R1, 2:G1, 3:R2, 4:G2, 5:R3, 6:G3, 7:R4, 8:G4, 9:R5, 10:G5, 11:R6, 12:G6, 13:R7,
14:G7, 15:R8, and 16:G8. (R is an abbreviation of “Red Tally,” and G of “Green Tally.”)
7
Press [Execute].
This makes the parallel tally settings, in accordance with the settings in
steps 1 to 6.
Deleting Parallel Tally Settings
1
In the Router/Tally >Parallel Tally menu, using any of the following
methods, select the parallel tally whose settings you want to delete.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
2
Press [Clear].
This deletes the selected parallel tally entry.
Knob Parameter Adjustment Setting values
1 Address Destination address 1 to 1024
2 Level Destination level 1 to 8
Knob Parameter Adjustment Setting values
3 Type Tally type
1 to 16
a)
Knob Parameter Adjustment Setting values
1 Slot No Parallel tally slot number 2 to 6
2 Port No Parallel tally port number 1 to 54
To Next Page
Loading...
Need help?
General