Chapter 19 Control Panel Setup (Panel)
1121
Overall Control Panel Settings (Config Menu)
Interchanging shifted and non-shifted operations for a dual M/E
1
In the Panel >Config menu, select the M/E bank for which the dual M/E
setting is made.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) Depends on the center control panel configuration.
2
Press [Dual M/E Xpt Swap], toggling it on or off.
On: The lower M/E bank is non-shifted, and the higher M/E bank is
shifted.
Off: The lower M/E bank is shifted, and the higher M/E bank is non-
shifted.
Assigning the Key Delegation in the Downstream Key
Control Block
As an example, to assign key 4 of the M/E-1 bank to key delegation button 1
of the downstream key control block 1, use the following procedure.
1
In the Panel >Config menu, press the [DSK Fader Assign].
The DSK Fader Assign menu appears.
2
Directly press on the indications in the status area, to select the
downstream key control block for which you want to make the setting, and
select the key delegation.
Here, press on the intersection of the “1st Module” column and “Key1
Assign” row.
3
In the <M/E Select> group, select the bank of the key you want to assign.
Here, select [M/E-1] as an example.
4
In the <Key Link Select> group, select the key you want to assign.
Here, select [Key4] as an example.
Knob Parameter Adjustment Setting values
1 Bank Bank to be selected for dual
M/E setting
1 to 4
a)
To Next Page
Loading...
Need help?
General