Chapter 7 Frame Memory
434
Managing Images Using a DDR/VTR
6
Press [Restore Start].
A confirmation popup window appears.
7
Start playback at the external device, and immediately after that press
[Yes].
Notes
Make sure to include that the red or blue image inserted at the beginning
when the backup was made. If this image is not found, the clip or still
image will not be played back correctly.
This starts the restore operation, and when completed a message appears.
8
Stop the playback at the external device, and press the [OK] button.
Extracting Images from Video Tape
By recording a clip or still image stored on a video tape as a single clip (single
file) under certain rules, you can automatically extract an image from the clip,
and save as a separate frame memory file.
Relation between recorded state of video tape and files after
extraction
The extraction is carried out according to the following rules.
Example 1: When only video signal clips and a still image are
recorded (single files)
Result of extraction:
Each section surrounded by red marker frames is extracted as a clip (main file).
If the red markers surround a single frame, then it is extracted as a still image.
In the case above two clip files (main files) are extracted, and one still image
file.
V: video Red: red marker frame
a)
Video tape
To Next Page
Loading...
Need help?
General