To Next Page

To Previous Page

Chapter 20 Switcher Setup (Switcher)

1220

Signal Output Settings (Output Menu)

For setup relating to signal outputs, use the Switcher >Output menu.

To display the Output menu

In the Engineering Setup menu, select VF3 ‘Switcher’ and HF3 ‘Output.’

The status area shows the output signal numbers and names, and output signal

phase for the signals output from Output 1 to 48.

The following functions are available here.

• Output Assign: Assign the signals output from the Output1 to 48 ports.

• Video Clip: Adjust the clip levels (White Clip, Dark Clip, and Chroma Clip)

for the output signals from each of the Output1 to 48 ports.

• V Blank: Adjust the vertical blanking width for the output signals from each

of the Output1 to 48 ports. The setting is the number of scan lines from the

reference blanking position of field 1 for the particular format which should

be masked.

• Through: Enable or disable through mode. Through mode can be enabled

for AUX1 to 48 outputs, M/E and PGM/PST program outputs, and clean

output.

• Safe Title: Enable or disable safe title, and carry out settings for box 1 and

2, cross and grid (for the MVS-8000G only).

• Ref. Output Phase: Set the reference output mode and phase adjustment

(for the MVS-8000/8000A only).

• 4:3 Crop: Set the actual video image to be cropped to a 4:3 aspect ratio when

an HD system has a screen aspect ratio of 4:3.

• FC Adjust (for MVS-8000G only): Set the format converter outputs.

Assigning Output Signals

To assign a signal to output from an output port, use the following procedure.

In the Switcher >Output menu, press [Output Assign].

The Output Assign menu appears.

The status area shows the output ports and assigned signals on the left, and

a list of signals that can be assigned on the right.

In the <Output Assign> group, select either of the following.

[Re-Entry Source]: It is possible to make duplicate assignments.

Sony MVS-8000 User Manual

Questions and Answers: