Chapter 19 Control Panel Setup (Panel)
1134
Overall Control Panel Settings (Config Menu)
3
Select the setting target (M/E-1 to M/E-3 or P/P) in the status area.
4
Select [Utility/S
hotbox] in the <PRE MCRO
/POST MCRO> group.
This assigns the utility/shotbox mode to the [PRE MCRO] button, and
disables the [POST MCRO] button.
Assigning the Function to Disable Cross-Point Button
Operations to a Button
1
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2
Press [Xpt Module].
The Xpt Module menu appears.
3
Using any of the following methods, select the bank.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
4
Press [Inhibit Set].
This assigns the function to disable cross-point button operations to the
[PRE MCRO] button.
Assigning the AUX Bus Control Mode Switching
Function
You can switch the cross-point control block of the CCP-6224/6324 control
panel to AUX bus control mode (AUX panel-less function). You can display
the names of the sources or buses for the AUX buses in the source name
displays.
The function for switching to AUX control (AUX Ctrl) mode is assigned to the
[PRE MCRO] button. And the function for switching the source name displays
to the names of the sources or buses for the AUX buses is assigned to the
[POST MCRO] button.
Knob Parameter Adjustment Setting values
1 Bank Bank selection 1 to 4
To Next Page
Loading...
Need help?
General