Chapter 17 Files
1015
Operations on Individual Files
Selecting a particular file displays more detailed information about that file
in the detail display area at the top right of the file list.
In the Frame Memory menu, the following items are also shown.
Pair: In the case of a pair file, “P” is shown.
Ext: In the case of an extended clip file, “Ext” is shown.
Selecting Regions
You can carry out a file operation on a number of regions simultaneously.
However, a region selection is not required for the following files.
• Key memory
• Video process memory
• Shotbox
• Macro
• Macro attachment
• Frame memory
•Setup
• Initial status
In the above list, for frame memory in Dual Simul mode you can select the
switcher to be used for the operation in a way similar to the region selection.
For setup and initial status, you can similarly separate the files to be operated
on by device.
To make a region selection
1
Press the region selection area at the top right of the screen (see page
1014).
The region selection window appears.
2
Press the region names you do not want to select, turning them off.
3
Press [OK].
Selecting a Device for Operations
To carry out file operations, you need to specify the device holding the data (or
file), as one of the following: register, hard disk, memory card, and so on. You
can then further select a directory.
If you have enabled NFS (Network File System) in setup, you can add
“Network” to the device for operations.
To Next Page
Loading...
Need help?
General