Sony MVS-8000 User Manual

Chapter 2 Menus and Control Panel
79
Names and Functions of Parts of the Control Panel
Move to the right to run the effect in the
normal direction, and to the left for the
reverse direction.
When the VTR/disk recorder/frame
memory operation mode is enabled
Moving the joystick sideways controls the
tape transport/disk drive/frame memory
clip operation, at a speed determined by the
operating buttons.
When the resizer control mode is enabled
(for the MVS-8000G only)
Move for operations in the x-, y-, and z-
axes. Hold down the button on the tip of the
joystick to switch the joystick operation to
a finer control. (fine mode)
Device Control Block (Search Dial)
The description below of frame memory
clip operations applies only to the MVS-
8000A/8000G.
Using the device control block (search
dial), you can directly operate an XDCAM,
disk recorder, VTR, other external device,
frame memory clip, or shotbox. The device
control block (trackball) and device control
block (joystick) can be used together.
1 Timecode display
2 Device selection buttons
4 DELAY button
5 Editing
buttons
6 External device
operation buttons
7 TIMELINE button
8 STOP button
9 Search dial
3 SBOX buttons

Sony MVS-8000 Specifications

General

Brand	Sony
Model	MVS-8000
Category	Switch
Language	English