Chapter 19 Control Panel Setup (Panel)
1127
Overall Control Panel Settings (Config Menu)
buttons on the memory recall section numeric keypad buttons, so that you can
select them, and set the assignment of regions to the numeric keypad buttons.
However, in the Multifunction Flexi Pad control block, it is not possible to
assign a region to the [EXIT] button.
For details of the Multifunction Flexi Pad control block, see “Multifunction
Flexi Pad Control Block” in Chapter 2 (Volume 1).
1
In the Panel >Config menu, press [10 Key Region Assign].
The 10 Key Region Assign menu appears.
When a CCP-6224 or CCP-6324 control panel including a Multifunction
Flexi Pad control block is connected, the display in the button area at the
lower part of the status area changes as follows.
The left side of the status area shows region selection buttons; the upper
part of the right side shows a list of regions assigned to region selection
buttons, and the lower part shows a list of assignable regions.
2
To assign regions to the region selection buttons in the Multifunction Flexi
Pad control block or the numeric keypad buttons in the memory recall
section, press either of the following buttons in the <Flexi Pad Area Sel>
group of the button area.
[Region Sel Btn Area] button: When assigning a region to the region
selection buttons
[Mem Rcl Btn Area] button: When assigning a region to the numeric
keypad buttons in the memory recall section
To Next Page
Loading...
Need help?
General