Chapter 6 DME Wipes
360
DME Wipe Settings for Independent Key Transitions
To set the operation for DME wipe crop transition execution
1
In the <Crop Mode> group of the Key1 DME Wipe Adjust menu, press
[Crop], turning it on.
2
In the <Crop Mode> group, press [Crop] or [4:3 Crop] (to crop to 4:3 in
16:9 mode), turning it on.
3
In the <Crop Mode> group, press [Remove From Begin].
The Remove From Begin menu appears.
For subsequent operations, see step 5 of “To set the action when a DME
wipe crop transition is executed” (page 354).
To set the timing of transition completion
1
In the <Crop Mode> group of the Key1 DME Wipe Adjust menu, press
[Crop], turning it on.
2
In the <Crop Mode> group, press [Remove From Begin].
For subsequent operations, see “Setting the timing of transition
completion” (page 355).
Applying a border to a key DME wipe
In the <Edge> group of the Key1 DME Wipe Adjust menu, press [Border],
turning it on.
For subsequent operations, use the same process as in step 4 of “Modifying the
DME wipe pattern edge” (page 350).
To Next Page
Loading...
Need help?
General