Chapter 7 Frame Memory
412
Frame Memory Clip Operations
To specify the playback start point
To make the current position the playback start point, press the [START TC]
button. To set a different position, press the [SET START TC] button, then
enter the timecode from the numeric keypad control block.
To specify the duration
Press the [SET DUR] button, and enter a timecode from the numeric keypad
control block. If the playback start point is already set, this automatically sets
the playback stop point. If the playback stop point is already set, this
automatically sets the playback start point. (The duration setting is not
displayed in the device control block.)
To specify the playback stop point
Start playback, and at the desired position press the [STOP] button to stop
playback, then press the [STOP TC] button. To set to any position, press the
[SET STOP TC] button, and enter a timecode from the numeric keypad control
block.
To carry out the variable speed playback
Use the search dial.
For details on using the search dial, see “Controlling the Tape/Disk
Transport” in Chapter 12 (Volume 2).
To apply a loop to a frame memory clip
Press the [LOOP] button.
Using the device control block (trackball) or device control block
(joystick) to play back clips
Notes
A frame memory clip must first be recalled with a menu operation.
1
Press the [DEV] button in the region selection buttons, and select the frame
memory clip for playback (FM1 CLIP to FM8 CLIP).
If the pair mode is on, both main and subsidiary FMs light.
2
Press the [PLAY] button, turning it on.
To stop playback, press [STOP] or any of the [SHTL], [JOG], [CUE],
[REW], [FF], and [ALL STOP] buttons.
For details of the buttons in the device control block (trackball) or device
control block (joystick), see “Device Control Block (Trackball)” (page 74) in
Chapter 2.
To Next Page
Loading...
Need help?
General