Chapter 10 Special Functions
509
Dual Link Support
• “Interfacing With External Devices (Device Interface Menu)” in Chapter 21
“DME Setup (DME)”
• “GPI Input Settings (GPI Input Assign Menu)” in Chapter 22 “Setup
(DCU)”
The available input reference signals are as follows.
Switching the signal type of DME output (video/key) assigned to
a monitor signal
The function for switching the signal type of the monitor output (one channel)
to video or key is assigned to one of the Prefs buttons of the Menu control block
or one of the buttons of the Utility/Shotbox control block (DME MON KEY
command).
For details of the assignment, see “Settings Button Assignment (Prefs/Utility
Menu)” in Chapter 19 (Volume 3).
To switch the signal type of DME output (video/key) assigned to a
monitor signal
Press the DME MON KEY command assigned button and turn it on to assign
DME key output to a monitor signal. Then press the button and turn it off to
assign DME video output to a monitor signal. For selection of the DME
channels to be assigned to a monitor signal, see “Assigning a DME output
signal as a monitor signal” (page 243).
Selecting the signal output from the DME monitor output
connector
1
Display the Engineering Setup >DME >Output >Monitor Output menu.
2
Press [DME1] or [DME2] to select the DME to operate on.
3
On the left, select MONI OUT#1 or MONI OUT#3.
4
On the right, select the signal.
You can select any of Ch1 Video, Ch1 Key, Ch2 Video, and Ch2 Key.
5
Press [Set].
Signal format Input reference signal
Tri Sync Black burst
1080P/59.94 59.94 Black Burst 59.94 Sync 59.94
1080P/50 50 Black Burst 50 Sync 50
To Next Page
Loading...
Need help?
General