Chapter 16 Macros
953
Macro Operations in the Standard Type Flexi Pad Control Block
• If the same register is recalled again during macro execution or when the
macro is paused, the following operation depends on a setting in setup.
For details of the settings, see “Setting the Macro Execution Mode” in
Chapter 19 (Volume 3).
• Individual events stored in a macro are executed according to the
settings in setup. If you change the settings in setup, a saved macro may
not have the expected effect.
• During macro execution, if you switch the control panel to macro editing
mode, the macro being executed stops.
• During macro editing it is not possible to execute a macro.
• While executing a macro with the numeric keypad control block,
Multifunction Flexi Pad control block, Flexi Pad control block for
another switcher bank, or with a button with a macro attachment set, if
you recall another macro with the Flexi Pad control block, the following
operation depends on a setting in setup.
For details of the settings, see “Setting the Macro Execution Mode” in
Chapter 19 (Volume 3).
Executing a macro in normal execution mode (with pause events
set)
When execution of a macro is paused, the [Take] button is assigned to the
memory recall section.
To restart the macro execution, press the [Take] button.
You can switch the normal execution mode and step execution mode in the
Setup menu. See “Setting the Macro Execution Mode” in Chapter 19 (Volume
3).
Executing a macro in step execution mode
To recall a macro register and execute the macro in step execution mode, use
the following procedure.
1
In the Flexi Pad control block, recall the macro register.
For details of recalling macro registers, see “Recalling a Macro Register
and Executing a Macro” (page 951).
The Flexi Pad control block memory recall section is assigned to the
display of the [Take] button and macro execution status, as in the following
figure.
To Next Page
Loading...
Need help?
General