Chapter 16 Macros
955
Macro Operations in the Standard Type Flexi Pad Control Block
This assigns the Flexi Pad control block to macro editing, and the auto
insert function is enabled. The [MCRO] button lights red.
As an example, when register 12 is specified, the buttons in the memory
recall section appear as in the following figure.
4
In the same way as in the numeric keypad control block, create the events
you want to save in the macro.
For details, see step 2 (page 942) of “Creating a new macro.”
5
Repeat step 4 to save the desired events in the macro.
The operations you carry out on the control panel are saved as a sequence
of events in the macro.
The numeric display appears as follows.
6
Press the [STORE XX] button in the memory recall section (where XX is
the register number).
The [STORE STATS] button lights amber.
This saves the created macro in the register, and macro editing ends.
The Flexi Pad control block returns to the state before macro editing began.
The [MCRO] button lights amber.
Notes
• During macro editing, you can press a mode selection button in the Flexi Pad
control block other than the [MCRO] button (for example, the [WIPE] button
or [DME] button) to record the executed operation as an event. In this case,
the [MCRO] button remains lit red.
Example:
Press to set a pause length.
“12” is the number of the currently
recalled register. Pressing this button
saves the macro, and the Flexi Pad
section switches back from macro
editing mode to the recall operation
mode.
Position of last saved event
Example:
Total number of events
To Next Page
Loading...
Need help?
General