284 RMON Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\RMON.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
rmon alarm
Use the rmon alarm Global Configuration mode command to configure
alarm conditions. Use the no form of this command to remove an alarm.
Syntax
rmon alarm
index mib-object-id interval rthreshold fthreshold revent fevent
[type {absolute | delta}]
[startup {rising | rising-falling | falling}] [owner name]
no rmon alarm
index
Parameters
•
index
—Specifies the alarm index. (Range: 1–65535)
Oversize The number of packets received during this sampling interval
that were longer than 1518 octets (excluding framing bits but
including FCS octets) but were otherwise well formed.
Fragments The total number of packets received during this sampling
interval that were less than 64 octets in length (excluding
framing bits but including FCS octets) and had either a bad
Frame Check Sequence (FCS) with an integral number of
octets (FCS Error), or a bad FCS with a non-integral number of
octets (Alignment Error). It is normal for etherHistoryFragments
to increment because it counts both runts (which are normal
occurrences due to collisions) and noise hits.
Jabbers The number of packets received during this sampling interval
that were longer than 1518 octets (excluding framing bits but
including FCS octets), and had either a bad Frame Check
Sequence (FCS) with an integral number of octets (FCS Error)
or a bad FCS with a non-integral number of octets (Alignment
Error).
Dropped The total number of events in which packets were dropped by
the probe due to lack of resources during this sampling interval.
This number is not necessarily the number of packets dropped,
it is the number of times this condition has been detected.
Collisions The best estimate of the total number of collisions on this
Ethernet segment during this sampling interval.
Field Description
To Next Page
Loading...
Need help?
General