Dell PowerConnect PC5524 User Manual

624 IPv6 Addressing Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\IPv6_Addressing.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
processing. The no ipv6 enable command removes the entire IPv6 interface
configuration.
To enable stateless address autoconfiguration on an enabled IPv6 interface,
use the IPv6 address autoconfig command.
Example
The following example enables VLAN 1 for the IPv6 addressing mode.
Console(config)# interface vlan 1
Console(config-if)#
ipv6 enable
ipv6 address autoconfig
Use the ipv6 address autoconfig Interface Configuration mode command to
enable automatic configuration of IPv6 addresses, using stateless
autoconfiguration on an interface. Addresses are configured depending on the
prefixes received in Router Advertisement messages. Use the no form of this
command to disable address autoconfiguration on the interface.
Syntax
ipv6 address autoconfig
no ipv6 address
autoconfig
Parameters
Thiis command has no arguments or keywords.
Default Configuration
Address autoconfiguration is enabled on the interface, no addresses are
assigned by default.
Command Mode
Interface Configuration (Ethernet, VLAN, Port-channel) mode.

Dell PowerConnect PC5524 Specifications

General

Brand	Dell
Model	PowerConnect PC5524
Category	Switch
Language	English