660 DHCP Server Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\DCHP_Server.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Parameters
•
address
—Specifies the client IP address.
•
mask
—Specifies the client network mask.
•
prefix-length
—Specifies the number of bits that comprise the address
prefix. The prefix is an alternative way of specifying the client network
mask. The prefix length must be preceded by a forward slash (/).
•
unique-identifier
—Specifies the distinct client identification in dotted
hexadecimal notation: Each byte in a hexadecimal character string is two
hexadecimal digits. Bytes are separated by a period or colon. For example,
01b7.0813.8811.66.
•
hardware-address
—Specifies the MAC address.
Default Configuration
DHCP hosts are not configured.
Command Mode
DHCP Pool Host Configuration mode
Example
The following example manually binds an IP address to a Dynamic Host
Configuration Protocol (DHCP) client.
Console(config-dhcp)#
address
10.12.1.99 255.255.255.0
01b7.0813.8811.66
address (DHCP Network)
Use the address DHCP Pool Network Configuration mode command to
configure the subnet number and mask for a Dynamic Host Configuration
Protocol (DHCP) address pool on DHCP Server. Use the no form of this
command to remove the subnet number and mask.
Syntax
address
{network-number | low low-address high high-address} {mask |
prefix-length}
no address
To Next Page
Loading...
Need help?
General