Dell PowerConnect PC5524 User Manual

Address Table Commands 387
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Address_Table.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
26
Address Table Commands
bridge multicast filtering
Use the bridge multicast filtering Global Configuration mode command to
enable the filtering of multicast addresses. Use the no form of this command
to disable multicast address filtering.
Syntax
bridge multicast filtering
no bridge multicast filtering
Default Configuration
Multicast address filtering is disabled. All multicast addresses are flooded to
all ports.
Command Mode
Global Configuration mode
User Guidelines
If multicast devices exist on the VLAN, do not change the unregistered
multicast addresses’ states to drop on the device ports.
If multicast devices exist on the VLAN and IGMP-snooping is not enabled,
the bridge multicast forward-all command should be used to enable
forwarding all multicast packets to the multicast switches.
Example
The following example enables bridge multicast filtering.
Console(config)# bridge multicast filtering

Dell PowerConnect PC5524 Specifications

General

Brand	Dell
Model	PowerConnect PC5524
Category	Switch
Language	English