Dell PowerConnect PC5524

LLDP Commands 429
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\LLDP.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Syntax
lldp optional-tlv tlv [ tlv2 … tlv5 ]
no lldp optional-tlv
Parameters
tlv—Specifies TLV that should be included. Available optional TLVs are:
port-desc, sys-name, sys-desc, sys-cap, 802.3-mac-phy, 802.3-lag, 802.3-max-
frame-size.
Default Configuration
No optional TLV is transmitted.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example specifies that the port description TLV is transmitted
on gigabitethernet port 1/0/2.
Console(config)# interfac e gigabitethernet 1/0/2
Console(config-if)# lldp optional-tlv port-desc
lldp management-address
Use the lldp management-address Interface Configuration (Ethernet) mode
command to specify the management address advertised from an interface.
Use the no form of this command to stop advertising management address
information.
Syntax
lldp management-address {ip-address | none | automatic [interface-id] }
no lldp management-address
Parameters
• ip-address —Specifies the static management address to advertise.
•
none —Specifies that no address is advertised.