DHCP Server Commands 661
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\DCHP_Server.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Parameters
•
network-number
—Specifies the IP address of the DHCP address pool.
•
mask
—Specifies the pool network mask.
•
prefix-length
—Specifies the number of bits that comprise the address
prefix. The prefix is an alternative way of specifying the client network
mask. The prefix length must be preceded by a forward slash (/).
•
low
l
ow-address
—Specifies the first IP address to use in the address range.
•
high
high-address
—Specifies the last IP address to use in the address
range.
Default Configuration
DHCP address pools are not configured.
If the low address is not specified, it defaults to the first IP address in the
network.
If the high address is not specified, it defaults to the last IP address in the
network.
Command Mode
DHCP Pool Network Configuration mode
Example
The following example configures the subnet number and mask for a
Dynamic Host Configuration Protocol (DHCP) address pool on DHCP
Server.
Console(config-dhcp)#
address
10.12.1.0 255.255.255.0
lease
Use the lease DHCP Pool Network Configuration mode command to
configure the time duration of the lease for an IP address that is assigned
from a Dynamic Host Configuration Protocol (DHCP) Server to a DHCP
client. Use the no form of this command to restore the default value.
To Next Page
Loading...
Need help?
General