Dell PowerConnect PC5524 User Manual

802.1x Commands 301
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\802.1X.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Console(config)# interface gigabitethernet 1/0/15
Console(config-if)# dot1x timeout quiet-period 3600
dot1x timeout tx-period
Use the dot1x timeout tx-period Interface Configuration (Ethernet) mode
command to set the time interval during which the device waits for a
response to an Extensible Authentication Protocol (EAP) request/identity
frame from the client before resending the request. Use the no form of this
command to restore the default configuration.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
Parameters
seconds—Specifies the time interval in seconds during which the device waits
for a response to an EAP-request/identity frame from the client before
resending the request. (Range: 1–65535 seconds)
Default Configuration
The default timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The default value of this command should be changed only to adjust to
unusual circumstances, such as unreliable links or specific behavioral
problems with certain clients and authentication servers.
Example
The following command sets the time interval during which the device waits
for a response to an EAP request/identity frame to 3600 seconds.
Console(config)# interface gigabitethernet 1/0/15
Console(config-if)# dot1x timeout tx-period 3600

Dell PowerConnect PC5524 Specifications

General

Brand	Dell
Model	PowerConnect PC5524
Category	Switch
Language	English