Dell PowerConnect PC5524 User Manual

Tunnel Commands 645
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Tunnel.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
no tunnel isatap router
Parameters
router-name—Specifies the router’s domain name.
Default Configuration
The automatic tunnel router's default domain name is ISATAP.
Command Mode
Interface Configuration (Tunnel) mode
User Guidelines
The ipv6 tunnel routers-dns command determines the string that the host
uses for automatic tunnel router lookup in the IPv4 DNS procedure. By
default, the string ISATAP is used for the corresponding automatic tunnel
types.
Only one string can represent the automatic tunnel router name per tunnel.
Using this command, therefore, overwrites the existing entry.
Example
The following example configures the global string ISATAP2 as the automatic
tunnel router domain name.
Console(config)# tunnel 1
Console(config-tunnel)#
tunnel isatap router ISATAP2
tunnel source
Use the tunnel source Interface Configuration (Tunnel) mode command to
set the local (source) IPv4 address of a tunnel interface. The no form deletes
the tunnel local address.
Syntax
tunnel source { auto | ipv4-address }
no tunnel source

Dell PowerConnect PC5524 Specifications

General

Brand	Dell
Model	PowerConnect PC5524
Category	Switch
Language	English