670 DHCP Server Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\DCHP_Server.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Example
The following example specifies boot_image_file as the default boot image
file name for a DHCP client.
Console(config-dhcp)#
bootfile
boot_image_file
time-server
Use the time-server DHCP Pool Configuration mode command to specify the
time servers list for a Dynamic Host Configuration Protocol (DHCP) client.
Use the no form of this command to remove the time servers list.
Syntax
time-server
ip-address
[
ip-address2
...
ip-address8
]
no time-server
Parameters
ip-address—Specifies the IP address of a time server. One IP address is
required, although up to eight addresses can be specified in one command
line.
Command Mode
DHCP Pool Host Configuration mode
DHCP Pool Network Configuration mode
Default Configuration
No time server name is defined.
User Guidelines
The router IP address should be on the same subnet as the client subnet.
Example
The following example specifies 10.12.1.99 as the time server IP address.
Console(config-dhcp)#
time-server
10.12.1.99
To Next Page
Loading...
Need help?
General