VLAN Commands 495
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\VLAN_ISCLI_Only.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
User Guidelines
If the VLAN does not exist (ghost VLAN), not all of the commands are
available under the interface VLAN context.
The commands that are supported for VLANs that do not exist are:
• IGMP snooping control commands
• Bridge multicast configuration commands
Example
The following example configures VLAN 1 with IP address 131.108.1.27 and
subnet mask 255.255.255.0.
Console (config)#
interface vlan
1
Console (config-if)#
ip address
131.108.1.27 255.255.255.0
interface range vlan
Use the interface range vlan Global Configuration mode command to enable
configuring multiple VLANs simultaneously.
Syntax
interface range vlan
vlan-range
Parameters
vlan-range—Specifies a list of VLAN IDs. Separate nonconsecutive VLAN
IDs with a comma and no spaces. Use a hyphen to designate a range of IDs.
Command Mode
Global Configuration mode
User Guidelines
Commands under the interface range context are executed independently on
each interface in the range. If the command returns an error on one of the
interfaces, an error message is displayed and command execution continues
on the other interfaces.
To Next Page
Loading...
Need help?
General