646 Tunnel Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Tunnel.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Parameters
•
auto
—The system minimum IPv4 address is used as the source address for
packets sent on the tunnel interface. If the IPv4 address is changed, then
the local address of the tunnel interface is changed too.
•
ip4-address
—Specifies the IPv4 address to use as the source address for
packets sent on the tunnel interface. The local address of the tunnel
interface is not changed when the IPv4 address is moved to another
interface (only if StackTable is changed).
Default
No source address is defined.
Command Mode
Interface Configuration (Tunnel) mode
User Guidelines
The configured source IPv4 address is used for forming the tunnel interface
identifier. The interface identifier is set to the 8 least significant bytes of the
SIP field of the encapsulated IPv6 tunneled packets.
Example
console(config)# interface tunnel 1
console(config-tunnel)#
tunnel source
auto
tunnel isatap query-interval
Use the tunnel isatap query-interval Global Configuration mode command
to set the time interval between Domain Name System (DNS) queries
(before the ISATAP router IP address is known) for the automatic tunnel
router domain name. Use the no form of this command to restore the default
configuration.
Syntax
tunnel isatap query-interval
seconds
no tunnel isatap query-interval
To Next Page
Loading...
Need help?
General