Dell PowerConnect PC5524 User Manual

668 DHCP Server Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\DCHP_Server.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Syntax
next-server ip-address
no next-server
Parameters
ip-address —Specifies the IP address of the next server in the boot process,
which is typically a Trivial File Transfer Protocol (TFTP) server.
Default Configuration
If the next-server command is not used to configure a boot server list, the
DHCP Server uses inbound interface helper addresses as boot servers.
Command Mode
DHCP Pool Host Configuration mode
DHCP Pool Network Configuration
mode
Example
The following example specifies 10.12.1.99 as the IP address of the next server
in the boot process.
Console(config-dhcp)# next-server 10.12.1.99
next-server-name
Use the next-server-name DHCP Pool Configuration mode command to
configure the next server name in the boot process of a Dynamic Host
Configuration Protocol (DHCP) client. Use the no form of this command to
remove the boot server name.
Syntax
next-server-name name
no next-server-name
Parameters
name—Specifies the name of the next server in the boot process. (Length:
1–64 characters)

Dell PowerConnect PC5524 Specifications

General

Brand	Dell
Model	PowerConnect PC5524
Category	Switch
Language	English