HP 530 User Manual

5-35
General System Configuration
Configuring SNMP
1. Click Management > SNMP and select the Traps tab.
2. Under the Trap Groups, check or uncheck the required traps boxes.
3. Click Update.
SNMP Trap Hosts
The SNMP – Trap Hosts screen allows configuration of the following SNMP
trap parameters:
■ Trap Destination Host (1 to 3): Enables/Disables recipients (up to
three) of SNMP notifications. For each destination, enter the IP address
or the host name, and the community name.
■ IP Address: Specifies the IP address or the host name (from 1 to 20
characters) for the recipient of SNMP notifications.
■ Community Name: The community string sent with the notification
operation. (Maximum length: 32 characters)
■ [Update]: Updates the Trap settings.
Figure 5-7. Configuring SNMP Trap Destinations
To Configure SNMP Trap Destinations:
1. Click Management > SNMP and select the Trap Hosts tab.
2. To set trap destinations, click Trap Destination Host 1, 2, or 3.

HP 530 Specifications

General

Brand	HP
Model	530
Category	Laptop
Language	English