9-72
Command Line Reference
MAC Address Authentication
MAC Address Authentication
Use these commands to define MAC authentication on the access point. For
local MAC authentication, first create the MAC authorization lists, enter the
MAC addresses to be filtered and then define the default filtering policy using
the address filter default command.
mac-auth-local
This command adds or removes entries in the local MAC address authentica-
tion control lists on the device.
Syntax
mac-auth-local <listname> mac <mac address> | <accept-list> | <deny-list>
no mac-auth-local <listname> mac <mac address>
• listname - Specifies the name of an entire MAC address authentication
control list. The no version of the command removes the MAC address
authentication list and all entries in the entire list.
• mac address - Specifies an entry in the authentication control list by
MAC address. The no version of the command removes the specific
MAC address entry from the specific MAC address authentication
control list. Valid format is 00:00:00:00:00:00 ~FF:FF:FF:FF:FF:FF.
• accept-list -The wireless stations whose MAC address is on the list
will be allowed access to the device.
• deny-list -The wireless stations whose MAC address is on the access
list will be prevented from having access to the device.
Command Function Mode Page
[no] mac-auth-local
<listname> mac
<mac address>
Sets [removes] the MAC addresses to be filtered. GC 9-72
[no] mac-auth-local
<listname> <accept
list| deny list>
Sets [removes] filtering to allow or deny listed
addresses.
IC-R-
WLAN
9-72
[no] mac-auth-
remote
Enables [disables] remote MAC authentication. IC-R-
WLAN
9-72
show mac-auth-local
[<name>]
Shows the MAC entries on the specified device. MC 9-74
To Next Page
Loading...
Need help?
General
