HP 530 User Manual

9-46
Command Line Reference
Network Management Application Commands
snmpv3 enable
This command enables and disables SNMPv3 functions on the access point.
Syntax
snmpv3 enable
[no] snmpv3 enable
Default Setting
Disabled
Command Mode
Global Configuration
Example
Related Commands
snmpv3 user-name (page 9-47)
show snmpv3 (page 9-47)
ProCurve Access Point 530# config
ProCurve Access Point 530(config)# snmpv3 enable
ProCurve Access Point 530(config)# show snmpv3
SNMPv3: Enabled
SNMP engine ID: 00:00:00:0b:00:00:00:14:c2:a5:6a:b3
SNMPv3 user accounts:
Username Auth. Protocol Privacy Protocol
-----------------------------------------------
tjameson MD5 AES
ProCurve Access Point 530(config)#
no snmpv3 enable
ProCurve Access Point 530(config)# show snmpv3
SNMPv3: Disabled
SNMP engine ID: 00:00:00:0b:00:00:00:14:c2:a5:6a:b3
SNMPv3 user accounts:
Username Auth. Protocol Privacy Protocol
-----------------------------------------------
tjameson MD5 AES
ProCurve Access Point 530(config)#

HP 530 Specifications

General

Brand	HP
Model	530
Category	Laptop
Language	English