9-10
Command Line Reference
General Commands
General Commands
These commands are used to configure the basic commands on the access
point.
configure
This command activates Global Configuration mode. You must enter this
mode to modify most of the settings on the access point. You must also enter
Global Configuration mode prior to enabling the context modes for Interface
Configuration.
See “Using the CLI” on page 3-6.
Command Function Mode Page
configure Set the current context level to the Global
Configuration level.
MC 9-10
copy See “Flash/File Commands” on page 9-50 9-51
end Sets the current context level to the Manager
Exec level.
MC 9-11
erase See “Flash/File Commands” on page 9-50 9-54
exit Sets the current command level to the
previous command level.
MC 9-11
log See “System Logging Commands” on
page 9-31
9-31
logout Terminates the CLI session. MC 9-12
ping Sends ICMP echo request packets to another
node on the network
MC 9-13
reload Perform a warm reboot. MC 9-14
Show Show operation information and parameters
for this device.
MC 9-14
terminal Sets dimensions of the terminal window. MC 9-16
write See “Flash/File Commands” on page 9-50 9-55
To Next Page
Loading...
Need help?
General
