6-20
Wireless Interface Configuration
Configuring the Radio
Configuring Pure G Mode
Figure 6-7. Configuring Pure G Mode
To Configure Pure G Mode:
The setting, shown in Figure 6-7, allows only g stations to associate with the
access point, but should be used only if no legacy 802.11b clients or access
points are within range of the 530 access point.
Caution This mode is not a standard-based configuration mode. If this mode is used
with legacy b stations and b access points, this mode creates a detrimental
effect leading to low throughput, especially with Protected Mode being
disabled.
1. Select Network Setup > Radio tab > IEEE 802.11g mode > [Edit] > Advanced
Settings.
2. Select Disable for Protected Mode, to set this radio parameter.
3. Deselect rate set values (11, 5.5, 2, and 1), using the Supported options.
4. Deselect rate set values (11, 5.5, 2, and 1) and select rate set values (24,
12, and 6) using the Basic options.
5. Select
[Update] to set the advanced radio parameters.
To Next Page
Loading...
Need help?
General
