HP 530 - Radius Failover-To-Local | Retransmit

9-66
Command Line Reference
RADIUS Accounting/Authentication
Default Setting
Disabled
Command Mode
WLAN Radio Interface Configuration
Example
radius failover-to-local | retransmit
This command configures RADIUS authentication failover and the RADIUS
retransmit retry parameter for this WLAN. To validate these settings, use the
show wlan <index> command, see
page 118.
Syntax
radius <failover-to-local | retransmit <limit>>
no radius
• failover-to-local - Enable the use of the local (built-in) RADIUS authen-
tication server in addition to any primary and secondary RADIUS
authentication server. The no version of the command disables use of
the local (built-in) RADIUS authentication server as an additional
server.
• retransmit <limit> - Set the number of retry attempts that are made to
a RADIUS authentication/accounting server until switching to the
next server on the list. The no version of the command is not available
for this parameter. (Valid values: 1-30)
Default Setting
Disabled. Retransmit value set to 3.
Command Mode
WLAN Radio Interface Configuration
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# wlan 1
ProCurve Access Point 530(radio1-wlan1)# radius-accounting
primary ip 192.168.1.52
ProCurve Access Point 530(radio1-wlan1)# radius-accounting
port 161
ProCurve Access Point 530(radio1-wlan1)# radius-accounting
key blue
ProCurve Access Point 530(radio1-wlan1)#