9-130
Command Line Reference
Wireless Security Commands
wep-key-length
This command sets the WEP key length when using static-wep security.
Syntax
wep-key-length <64|128>
• 64 - The 64 bit wep key length (with initializing vector, otherwise it is
40 bits).
• 128 - The 128 bit wep key length (with initializing vector, otherwise it
is 104 bits).
Default Setting
128
Command Mode
WLAN Interface Configuration
Example
wep-key
This command defines the wep-keys used for static-wep security.
Syntax
wep-key <1 | 2 | 3 | 4> <key>
• <1 | 2 | 3 | 4> - Set the first, second, third, and fourth wep keys used with
static-wep security (1-4).
• key - Sets the character string for security. The number of characters
depend on the number of characters required for each WEP key
depends on the Key Length and Key Type settings:
– If Key Length is 40 bits and the Key Type is "ASCII", then each
WEP key must be five (5) characters long.
– If Key Length is 40 bits and Key Type is "Hex", then each WEP key
must be 10 characters long.
– If Key Length is 104 bits and Key Type is "ASCII", then each WEP
Key must be 13 characters long.
– If Key Length is 104 bits and Key Type is "Hex", then each WEP
Key must be 26 characters long.
ProCurve Access Point 530(radio1-wlan1)# wep-key-length 64
ProCurve Access Point 530(radio1-wlan1)#
To Next Page
Loading...
Need help?
General
