3-11
Using the Command Line Interface (CLI)
Using the CLI
Options for Getting Help in the CLI
At any command level in the AP530 CLI you can:
â– Display all commands available at that level
â– Display the completion of a command you have started to type
â– Display the next options available for the command you are currently
entering.
Displaying All Available Commands
To display all commands available at the current command level, type "?" or
press the
[Tab] key.
Note At a given command level you can display the commands that level offers, plus
any relevant commands available at preceding levels. For example, at the
Global Configuration level, you can display Global Configuration commands
plus all the commands available at the lower Manager Exec level.
For example, typing "?" at the Manager Exec level produces this listing:
Figure 3-3. Example of the Manager Exec Level Command Listing
ProCurve Access Point 530# ?
configure Enter the Configuration context.
copy Copy data and configuration files to/from this device.
deauth-mac Enter MAC address to de-authenticate from this device.
end Return to the Manager level context.
erase Erase stored files.
exit Return to the previous context or terminate current cons
ole/telnet session if you are in the Manager context lev
el.
log Display all the entries in the event log.
logout Terminate this session.
page Toggle paging mode.
ping Send ICMP Ping requests to a device on the network.
reload Warm reboot of the device.
show Show operation information and parameters for this devic
e.
terminal Set the dimensions of the terminal window.
write View or save the running configuration of this device.
ProCurve Access Point 530#
To Next Page
Loading...
Need help?
General
