To Next Page

To Previous Page

9-52

Command Line Reference

Flash/File Commands

Syntax

copy custom-default startup-config

Default Setting

N/A

Command Mode

Manager Exec

Example

In this example, the copy custom-default startup-config command resets the

startup configuration to the same setting as the custom-default configuration.

Related Commands

erase (page 9-54)

copy startup-config

This command copies the startup configuration file from the device to the

specified remote server.

Syntax

copy startup-config <ftp | scp | tftp> <flash | startup-config> <ip> <file> [user-

name <user> password <pass>]

• startup-config-Specify that the type of file to copy, is the startup

configuration file.

• ftp | scp | tftp-Specify the type of remote server where the file will be

placed. Possible servers are File Transfer Protocol (FTP), Secure

Copy Protocol (SCP), and the Trivial File Transfer Protocol (TFTP).

• ip-The IP address of the remote server.

• file-The filename of the file on the remote server.

• user-name <user> password <pass>-Specify the username and pass-

word for the FTP and SCP remote servers. These parameters are not

used for TFTP.

Default Setting

ProCurve Access Point 530# copy custom-default startup-

config

ProCurve Access Point 530#

HP 530 User Manual

Other manuals for HP 530