5-5
General System Configuration
AP Network Configuration Checklist
AP Network Configuration Checklist
In setting up your Access Point for network installation, this manual covers
many of the tasks that should be considered for proper security and manage-
ment. Each of these tasks are detailed in their respective sections, however,
this summary is provided as an aid for establishing your network.
Table 5-1. Network Installation & Security Configuration Summary
Physical Security
Using a Kensington Lock.
See the ProCurve AP 530 Installation and Getting Started Guide.
Using back panel covers to hide access to buttons and cable connections.
See the ProCurve AP 530 Installation and Getting Started Guide.
Disabling device reset and clear buttons. page A-18
Disabling console access to the CLI interface. page 5-9
Management Interfaces
Changing the default settings for password. page 5-6
Limiting management access to the Ethernet side of the AP (disabling wireless access to remote
management interfaces).
page 5-9
Disabling unused remote management interfaces (Web, Telnet, SSH, SNMP). page 5-9
Changing the default settings for SNMP read and read/write community names. page 5-25
Changing the default settings for SNMPv3. page 5-38
Configuring capture of operating events to a server. page 5-45
Configuring the access point to limit remote management to a management VLAN. page 5-57
Wireless LAN Security
Setting WLAN security to utilize WPA/WPA2. page 5-57
Configuring multiple SSIDs to utilize separate VLANs. page 5-57
Configuring local user authentication. page 5-57
Configuring primary and secondary remote RADIUS user authentication. page 5-57
Configuring Identity-Driven Management features. page 5-57
Restricting access between wireless client devices associated with the same access point. page 5-57
To Next Page
Loading...
Need help?
General
