HP 530 User Manual

9-79
Command Line Reference
Web Authentication Commands
Web Authentication Commands
The commands described in this section are used to enable and configure Web
Authentication (Web-Auth) in the Access Point 530.
Command Function Mode Page
Global
[no] web-auth Enables 802.1X authentication
using a Web-browser interface
on the access point.
IC-R-
WLAN
9-82
[no] web-auth starting-ip-address <ip-
address> <subnet-mask>
Specifies the first IP address and
subnet mask that define the pool
of temporary IP addresses used
for initial Web-Auth connections.
GC 9-80
web-auth lease-time <ip-address> Specifies the period in seconds
of the IP lease for the pool of
temporary Web-Auth addresses.
GC 9-80
[no] web-auth guest-username
<username>
Specifies the username that will
be used for Guest user logins
using Web-Auth.
GC 9-81
[no] web-auth guest-password
<password>
Specifies the password that will
be used for Guest user logins
using Web-Auth.
GC 9-81
show web-auth Displays the current Web-Auth
settings.
MC 9-85
Per WLAN
[no] web-auth guest-login Enables or disables Web-Auth
for Guest users on the selected
WLAN.
IC-R-
WLAN
9-82
[no] web-auth username-
login Enables or disables Web-Auth
for Registered users on the
selected WLAN.
IC-R-
WLAN
9-82
[no] web-auth redirect-url Specifies the URL the user is
redirected to following
successful Web Authentication.
IC-R-
WLAN
9-82
web-auth retry-limit <retries> Specifies the number of failed
login attempts (from 1 to 9) a user
may make before logins are
refused by the access point.
Default is 3 attempts.
IC-R-
WLAN
9-82

HP 530 Specifications

General

Brand	HP
Model	530
Category	Laptop
Language	English