HP 530 User Manual

5-36
General System Configuration
Configuring SNMP
3. Enter the IP address in the Trap Destination IP Address field and enter
one of the configured community names in the Community Name field.
4. Select [Update].
CLI: Configuring SNMP v1 and v2c Traps
CLI Commands Used in This Section
To send SNMP v1 and v2c traps to a management station, specify the host IP
address using the snmp-server host command and enable specific traps using
the snmp-server trap command.
CLI: Configuring SNMP v1 and v2c Trap Destinations
CLI Commands Used in This Section
To send SNMP v1 and v2c traps to a management station, specify the host IP
address using the snmp-server host command and enable specific traps using
the snmp-server trap command.
Command Syntax CLI Reference Page
[no] snmp-server trap <trap> 9-43
show snmp-server 9-45
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# snmp-server trap
radiusAcctUpdate
ProCurve Access Point 530(config)#
Command Syntax CLI Reference Page
[no] snmp-server host <host_ip_address | host_name>
<community-string>
9-40
show snmp-server 9-45
ProCurve Access Point 530(config)# snmp-server host 192.168.
1.15 public
ProCurve Access Point 530(config)# snmp-server host 192.168.
1.19 public
ProCurve Access Point 530(config)#

HP 530 Specifications

General

Brand	HP
Model	530
Category	Laptop
Language	English