HP 530 - Cli-Confirmation; Console

9-23
Command Line Reference
System Management Commands
This example shows how to disable all the push button capabilities.
cli-confirmation
This command enables all CLI confirmation dialog prompts on the device. The
no command disables this ability.
Syntax
cli-confirmation
no cli-confirmation
Default Setting
Enabled
Command Mode
Global Configuration
Example
console
This command enables the serial console on the access point. The no version
disables the serial console on the access point. The no console command will
not work if the factory reset button is already disabled (e.g." no buttons
factory-reset" has been executed).
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# no buttons custom-reset
ProCurve Access Point 530(config)# no buttons factory-reset
ProCurve Access Point 530(config)# no buttons password-reset
ProCurve Access Point 530(config)# no buttons system-reset
ProCurve Access Point 530(config)#
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# cli-confirmation
ProCurve Access Point 530(config)#