9-87
Command Line Reference
Filtering Commands
show ap-authentication
This command displays the current AP Authentication settings on the device.
Syntax
show ap-authentication
Default
none
Command Mode
Global Configuration
Example
Filtering Commands
The commands described in this section are used to filter communications
between wireless stations, control access to the management interface from
wireless stations, and filter traffic using specific Ethernet protocol types.
ProCurve Access Point 530(config)# show ap-authentication
Status: Enabled
EAP Type: peap
ProCurve Access Point 530(config)#
Command Function Mode Page
[no] inter-station-
blocking
Enables communication between wireless
stations.
GC 9-88
[no] wireless-mgmt-
block
Enables communication between wireless
stations.
GC 9-88
show filters Display filter details. MC 9-89
To Next Page
Loading...
Need help?
General
