HP 530 User Manual

9-116
Command Line Reference
Wireless Interface Commands
Command Usage
• The radio operates at maximum power when this parameter is set to
0 dB.
• It may be necessary to apply Tx Power Reduction, if your antenna
gain causes the radio power to exceed the regulatory domain limit.
• You may also want to apply Tx Power Reduction to avoid overlap with
another access point coverage area (Default is 0)
Example
enable (wireless)
This command enables either the radio, ssid, or wds interfaces.
Syntax
enable
Default Setting
N/A
Command Mode
Radio Interface Configuration
WDS Interface Configuration
WLAN Interface Configuration
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# tx-power-reduction 5
ProCurve Access Point 530(radio1)#
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# enable

HP 530 Specifications

General

Brand	HP
Model	530
Category	Laptop
Language	English