9-99
Command Line Reference
Ethernet Interface Commands
Example
show ip
This command displays the IP address information, static default gateway
router configuration and the DHCP client configuration/status on the device.
Syntax
show ip
Default Setting
N/A
Command Mode
Manager Exec
ProCurve Access Point 530# show interface ethernet
Ethernet interface:
---------------------
Description Ethernet
MAC address 00:14:C2:A5:08:CB
Speed-duplex auto
Administrative status Enabled
Link status [add-in-future]
Management VLAN ID 1 (U)
Untagged-VLAN ID 1
Spanning Tree (STP) Enabled
STP Port State forwarding
STP Hello Interval 10.0
STP Forward Delay 10
STP Bridge Priority 255
Bytes Rx 70912184 Bytes Tx 30955292
Packets Rx 194926 Packets Tx 286333
Compressed Rx 0 Compressed Tx 0
Mcast packets Rx 0 Carrier errors Tx 0
Dropped Rx packets 0 Dropped Tx packets 0
FIFO overflows Rx 0 FIFO overflows Tx 0
Frame errors Rx 0 Packet collisions Tx 0
Total Rx errors Total Tx errors 0
ProCurve Access Point 530#
To Next Page
Loading...
Need help?
General
