3-14
Using the Command Line Interface (CLI)
Using the CLI
Displaying Available Command Options
You can display a reminder of the options available for the current command
by entering "?" or the [Tab] key in place of the next option. For example, to see
the command options for configuring SNMP:
Figure 3-5. Example of How To List the Options for a Specific Command
ProCurve Access Point 530(config)# snmp-server ?
community Add/remove an SNMP community.
contact Specify a text string that identifies the main contact f
or this device.
host Add/remove an SNMP trap destination host/community.
location Specify a text string that identifies the location of th
is device.
port Specify the port to use for the SNMP server on this devi
ce.
trap Enable/disable specific SNMP traps.
enable Enable SNMPv1/v2c.
ProCurve Access Point 530(config)#
To Next Page
Loading...
Need help?
General
