9-31
Command Line Reference
System Logging Commands
System Logging Commands
These commands are used to configure system logging on the access point.
log
This command displays all the entries in the event log on the device. This
command is functionally the same as the show logging command.
Syntax
log
Default Setting
N/A
Command Mode
Manager Exec
Command Function Mode Page
log Displays all log entries in access point memory. MC 9-31
[no] logging
<syslog_host>
[syslog_port]
Adds a syslog server host IP address and assign a port
number that will receive logging messages.
GC 9-32
show debug Displays the debugging results. MC 9-33
show logging Displays the state of logging. MC 9-33
To Next Page
Loading...
Need help?
General
