6-21
Wireless Interface Configuration
Configuring the Radio
CLI: Configuring Radio Settings
CLI Commands Used in This Section
Note You must set the country code before configuring the radio settings. These
basic settings affect the radio channels and values that are available for other
parameters. See
“Setting the Country Code” on page 6-4. Use the write mem
command to save the setting.
Configuring One Radio. The following example details how to enable one
radio and configure specific radio parameters on the access point.
Note Enter radio commands one line at a time.
.
Command Syntax CLI Reference Page
description <string> 9-117
[no] basic-rate <value> 9-107
beacon-interval <value> 9-109
fragmentation-thresh <value> 9-112
rts-threshold <value> 9-114
show stations 9-123
show radio <radio> 9-117
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# description “Radio 1 -
802.11g”
ProCurve Access Point 530(radio1)# beacon-interval 102
ProCurve Access Point 530(radio1)# fragmentation-thresh 1024
ProCurve Access Point 530(radio1)# rts-threshold 2000
To Next Page
Loading...
Need help?
General
