9-22
Command Line Reference
System Management Commands
Example
buttons
This command enables the ability to clear the password(s) and/or configura-
tion(s) via the buttons on the device. The no command disables this ability.
Syntax
buttons <custom-reset | factory-reset | password-reset | system-reset>
• custom-reset - Enables the ability to reset this device to the custom-
default configuration via the buttons. The no version of the command
disables this devices ability to reset this device to the custom-default
configuration via the buttons.
• factory-reset - Enables the ability to reset this device to the factory-
default configuration via the buttons. The no version of the command
disables this devices ability to reset this device to the factory-default
configuration via the buttons. The no buttons factory-reset command
will not work if the serial console is already disabled (e.g." no console"
has been executed).
• password-reset - Enables the ability to reset the password(s) on this
device via the buttons. The no version of the command disables this
devices ability to reset the password(s) on this device via the buttons.
• system-reset - Enables the ability to reset the system via the buttons.
The no version of the command disables this devices ability to reset
the system via the buttons.
Default Setting
Enabled
Command Mode
Global Configuration
Example
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# password manager admin
To Next Page
Loading...
Need help?
General
