To Next Page

To Previous Page

3-8

Using the Command Line Interface (CLI)

Using the CLI

Command Levels

Figure 3-2. Access Sequence for Command Levels

Configuration commands on the Access Point 539 are grouped into three

levels:

Manager Exec Level

Manager Exec level allows you to examine the current configuration, perform

basic system-level actions, reset the access point, and move to the configura-

tion access levels. The prompt for the Manager Exec level contains only the

system name and the "#" delimiter. For example:

ProCurve Acess Point 530 #

Global Configuration Level

Global Configuration level gives access to commands for configuring the

access point’s software features, plus all the commands available at the lower

Manager Exec level (except for the "configure [terminal]" command).

To enter this level, enter the configure command at the Exec prompt. The

prompt for this level adds the word "(config)" before the "#" delimiter. For

example:

ProCurve Acess Point 530# configure

ProCurve Acess Point 530(config)#

1. Manager Exec Level

2. Global Configuration Level

3. Context Configuration Level

Interface & WDS Levels

Radio Level:

WLAN Sub Configuration

HP 530 User Manual

Other manuals for HP 530