3 TRANSMISSION
1900P30390
B2410 •
B271
0 • B2910 WSM, 12271
Clearance between Differential Pinion Shaft and Differential
Pinion
1.
Measure the differential pinion shaft
0.0.
with
an
outside
micrometer.
2.
Measure the differential pinion
1.0.
with
an
inside micrometer,
and
calculate the clearance.
3.
If
the clearance exceeds the allowable limit, replace faulty parts.
Factory spec.
0.016 to 0.045 mm
Clearance between
0.0006 to 0.0018 in.
differential pinion shaft
and differential pinion
Allowable limit
0.30 mm
0.0118 in.
Differential pinion I.D.
Factory spec.
16.000 to 16.018 mm
0.6299 to 0.6306 in.
Differential pinion shaft
Factory spec.
15.973 to 15.984 mm
a.D.
0.6289 to 0.6293 in.
11900830530
Backlash between Differential Pinion and Differential Side
Gear
1.
Secure the differential case with a vise.
2.
Set the dial indicator (lever type) with its finger on the tooth of the
differential side gear.
3.
Press differential pinion and side gear against the differential
case.
4.
Hold the differential pinion and move the differential side gear to
measure the backlash.
5.
If
the backlash exceeds the allowable limit, adjust with
differential side gear shims.
Factory spec.
0.1
to 0.3 mm
Backlash between
0.004 to 0.012 in.
differential pinion and
OAmm
differential side gear
Allowable limit
0.016 in.
• NOTE
• Thickness of shims :
0.8 mm (0.0315 in.), 1.0 mm (0.0394 in.), 1.2 mm (0.0472 in.)
11900830540
3-S34
To Next Page
Loading...
Need help?
General
