82410 •
82710
• 82910 WSM, 12271
(12) Check Points of Every 2 Years
G GENERAL
Replacing Radiator Hose (Water Pipes)
1.
Replace the hoses and clamps.
Refer to
"Checking Radiator Hose and Hose Clamp". (See
page G-23.)
12271G00180
Replacing Fuel Hose
1.
Replace the fuel hoses and clamps,
if
necessary.
Refer to "Checking Fuel Line". (See page G-23.)
12271G00190
Flush Cooling System and Changing Coolant
A CAUTION
• Do not remove the radiator cap when the engine
is
hot.
Then loosen cap slightly to the stop to relieve any excess
pressure before removing cap completely.
1.
Stop the engine and let cool down.
2.
To drain the coolant, open the radiator drain cock, and remove
radiator cap. The radiator cap must
be
removed to completely
drain the coolant.
3.
After all coolant
is
drained, close the drain plug.
4.
Fill with clean water and cooling system cleaner.
5.
Follow directions of the cleaner instruction.
6.
After flushing, fill with clean water and anti-freeze until the
coolant level
is
just below the port.
7.
Start and operate the engine for few minutes.
8.
Stop the engine. Check coolant level and add coolant
if
necessary.
9.
Install the radiator cap securely.
• IMPORTANT
• Do not start engine without coolant.
• Use clean, fresh water and anti-freeze to fill the radiator.
• When the anti-freeze is mixed with water, the anti-freeze
mixing ratio must be less than 50
0/0.
• Securely tighten radiator cap. If the cap
is
loose or
improperly fitted, water may leak out and the engine could
overheat.
3.8 L
82410
4.0 U.S.qts
Coolant capacity
3.3Imp.qts
(with recovery tank)
82710
4.5 L
82910
4.8 U.S.qts.
4.0 Imp.qts.
(1)
Radiator Cap
G-27
(2) Drain Plug
12271G00200
To Next Page
Loading...
Need help?
General
